https://wiki.autosportlabs.com/index.php?title=Dual_LED_cluster&feed=atom&action=historyDual LED cluster - Revision history2024-03-28T12:25:25ZRevision history for this page on the wikiMediaWiki 1.38.6https://wiki.autosportlabs.com/index.php?title=Dual_LED_cluster&diff=802&oldid=prevBrentp: Dual LED cluster assembly/wiring2008-04-28T07:05:58Z<p>Dual LED cluster assembly/wiring</p>
<p><b>New page</b></p><div>Images for the Dual LED cluster<br />
==Dual LED cluster==<br />
[[Image:dual_led_cluster_kit.jpg|320px]]<br />
<br>Kit components<br />
<br />
==Assembly instructions==<br />
<br />
===Before starting===<br />
* Do not switch the Red and blue LEDs! Due to voltage differences it is critical you use the red LEDs in the inner ring of the array and blue LEDs in the outer.<br />
* If you feel you need to test the LEDs before installing- for example, if you mixed up the LEDs, you can test the individual LEDs by applying '''2V''' to the red LEDs and '''3V''' to the blue LEDs. Do not exceed the rated voltage or you will damage the LED!<br />
<br />
===Red cluster===<br />
Insert the Red LEDs into the inner ring of the printed circuit board. Ensure the flat side of the LED matches the flat on the circuit board. Also check that the LED is flat against the circuit board- bend the leads on the back side of the board at an angle to keep the LEDs from falling out.<br />
<br />
===Blue cluster===<br />
Repeat the same procedure for the Blue LEDs, inserting the LEDs into the outer ring of the circuit board.<br />
<br />
===Jumper wires for R1 and R2===<br />
<br />
Use a small jumper wire- or trimmed LED lead- to brige R1 and R2. Alternatively, you can also use these pads to wire in a resistor should you wish to reduce the array's brightness.<br />
<br />
==Wiring==<br />
<br />
* Connect '''+12V''' to +12 power, preferably switched ignition supply<br />
* Connect '''A1''' (RED array) and '''A2'''(Blue array) to ground via a switch, relay, or through one of the user defined outputs if you are controlling this cluster with the MegaJolt Lite Jr. See the wiring diagram for the MJLJ version you are running for more information.<br />
<br />
==Results==<br />
[[Image:dual_led_cluster_blue.jpg|320px]]<br />
<br>Blue cluster illuminated<br />
<br />
[[Image:dual_led_cluster_red.jpg|320px]]<br />
<br>Red cluster illuminated</div>Brentp