RaceCapturePro TelemetryQuickstart

Unbox

Install SIM Card into Telemetry Module

Purchasing SIM Card

  • T-Mobile

Purchase a "Pay By the Day" SIM card from your local t-mobile dealer. We recommend picking a plan with the 2G/3G unlimited data, which is currently $3 USD/day. The plan is only charged when data is actually used during a 24 hour period. Visit T-Mobile for more details on prepaid plans.

  • AT&T

AT&T is not currently supported; expect support soon in an upcoming firmware version.

Installing SIM card

  • Open telemetry enclosure

Unscrew the end plate on the antenna side of the telemetry module and slide the board from the case.

Telemetry unit half in enclosure.jpg

Unlatch SIM card holder

Unlatch the card holder by gently sliding the cover in the 'open' direction and swing the cover open.

Insert SIM card

Insert the SIM card, taking note of the beveled edge. The SIM card can only be inserted in one direction.

Telemetry sim chip cover open.jpg

Latch simcard holder in place

Swing the cover closed and slide towards the 'lock' position. take care that the cover is locked on both sides of the holder and it is flush with the board. Telemetry unit sim cover closed.jpg

Re-assemble case

Slide board back into enclosure. Ensure LEDs are aligned with end plate and reattach end plate with screws.

  • You may need to gently press the LEDs down flush against the board in order for them to line up with the holes in the opposite end plate.

Connect components

Telemetry Module

  • Plug cable in to connectivity expansion port (the port closest to the LEDs)

Connecting Antenna

  • Connect antenna to RF port
    • Don't overtorque!

Telemetry unit white.jpg

Connect Telemetry module to RaceCapture

  • Connect Telemetry module to connectivity port (port to the right of pushbutton switch)

Rcp and telemetry connected.jpg

Create a RCLive account and register your device

  • Go to http://www.race-capture.com, click on Signup in the top navigation
  • Create your account
  • After creating your account you will be prompted to add your device. Do it :)
  • Once added you will be given a device id, save this, you'll need it soon.

Install RaceAnalyzer

Follow the software installations instructions here: http://www.autosportlabs.net/RaceCapturePro_SoftwareOperation

Configure RaceCapture/Pro

Set channel sample rates

The default sample rates are too high for real-time telemetry, set the following sensors to these recommended values:

  • GPS 1Hz -5Hz
  • Accelerometer 5Hz

Set device id

Add your device id that you wrote down when adding your device to race-capture.com to the Telemetry Device Id field under the Logging/Telemetry section: Devicesetup.png

Write configuration

  • Click the 'Write' button in RaceAnalyzer
  • Power cycle RCP (turn off then on again)

Testing

RaceCapture/Pro with GPS & telemetry needs more power than a regular USB port can supply. You'll either need to connect it to your car's power directly, via a cigarette power adapter with wires or a powered usb hub similar to these:

Press the black switch on the front of your RaceCapture/Pro device to start logging.

Watch LEDs on telemetry device explain / document LED flashing Got to race-capture.com/home, look for a new event, click on it

TaDa!

View your live telemetry! Race faster!