Latest revision as of 22:28, 22 June 2019

Honda vehicles with B Series engines

Use ECU Pin A13

RaceCapture/Pro Settings:
- Timer Mode: RPM
- Pulse per revolution: 2
- Timer Speed: Medium

Fuel Level - Yel/Blk wire. This wire runs from the fuel level sending unit to the gauge cluster.

Disconnect the wire from the gauge cluster. You need to use a 47ohm pull-up resistor. The voltage range is 0.45 (full)- 3.5v (empty).

Recommend a dedicated 10 bar / 145 PSI 0.5-4.5v pressure sensor. Pressure Sensor

@@ Line 3: / Line 3: @@
 ==RPM==
-* Use pin A21 on OBD1 socket
+Use ECU Pin A13
 * RaceCapture/Pro Settings:
 ** Timer Mode: RPM
-** Pulse per revolution: 4
+** Pulse per revolution: 2
 ** Timer Speed: Medium
-==Engine Temperature==
+==Fuel Level==
-''In research''
+Fuel Level - Yel/Blk wire. This wire runs from the fuel level sending unit to the gauge cluster.
-==Fuel Level==
+* If not using the gauge cluster
-''In reserach''
+Disconnect the wire from the gauge cluster. You need to use a 47ohm pull-up resistor. The voltage range is 0.45 (full)- 3.5v (empty).
+* Channel settings
+** Sample Rate - 1hz
+** Smoothing - Max
+** Mapped
+** 0.45 - 100%
+** 3.5 - 0%
 ==Oil Pressure==
 Recommend a dedicated 10 bar / 145 PSI 0.5-4.5v pressure sensor. [https://www.autosportlabs.com/product/10-bar-145-psi-fluid-pressure-sensor/ Pressure Sensor]