IgnitionDrivers: Difference between revisions

(→‎Downloads: updated filename)
No edit summary
Line 14: Line 14:
* 10 pin molex connector for ease of use
* 10 pin molex connector for ease of use
* LEDs indicating driver activity (requires additional drive current of 3-6ma)
* LEDs indicating driver activity (requires additional drive current of 3-6ma)
* Heat-sinking from bottom of PC board- transistors are soldered down to PC Board.
* Heat-sinking from ''bottom'' of PC board- transistors are soldered down.
* 2.48 x 3.14" board sized to fit our compact aluminum enclosure (or other enclosure accepting 2.5" width PC Boards)
* 2.48 x 3.14" board sized to fit our compact aluminum enclosure (or other enclosure accepting 2.5" width PC Boards)



Revision as of 01:59, 2 February 2011

Ignition Driver boards

Jolt4 Ignition Driver

The Jolt4 Ignition Driver board groups together 4 Ignition drive transistors such as the Bosch BIP373 , Fairchild ISL9V3040S3ST and so on.

Jolt4 brd.png

Jolt4 sch.png

Features

  • Up to 4 ignition drivers supported
  • 10 pin molex connector for ease of use
  • LEDs indicating driver activity (requires additional drive current of 3-6ma)
  • Heat-sinking from bottom of PC board- transistors are soldered down.
  • 2.48 x 3.14" board sized to fit our compact aluminum enclosure (or other enclosure accepting 2.5" width PC Boards)

Connector Pinout

Jolt4 pinout.png

License

This design is released under the Autosport Labs Creative Commons license

Downloads

Revision A Hardware