CAN Bus Integration
Revision as of 21:44, 8 January 2015 by Jstoezel (talk | contribs) (→Controlling a CAN enabled Device)
Introduction
Researching CAN Bus protocol
Reverse Engineering
Reading a CAN message
Mapping to a Virtual Channel
Controlling a CAN enabled Device
AIM Mychron 3 Dash
The following information is a sum up of reverse engineering findings documented here: [1]. Example of LUA implementation of the the different packets documented on the Mychron 3 Hack page are provided below:
Packet 401h: RPM, Speed, Gear blink control, Gear
TODO
Packet 402h: Temperature/Pressure fields (bottom left of display)
TODO
Packet 404h: Control for fields displayed on bottom left of display
TODO
Packet 405h: Shift LEDs, Alarm LEDs
TODO
Packet 406h: RPM range for the digital RPM readout
TODO
TODO
