Sequential shift light array

Kit assembly

Install Resistors

• R1,R2 Install included 100 ohm resistor (marked 101)

• R3,R4,R5 Install included 270 ohm resistor (marked 271)

Install LEDs

Install LEDs so that the flat side on the LED case matches the outline on the board silkscreen.

• Cluster A1,A2: Install green LEDs for L1 - L8
• Cluster A3,A4: Install yellow LEDs for L9 - L16
• Cluster A5: Install Red LEDs for L17 - L20

Wiring

Basic Operation

Wire pad +12v to ignition switched +12V.

To activate the following clusters:

• Cluster 1: Connect A1 to ground
• Cluster 2: Connect A2 to ground
• Cluster 3: Connect A3 to ground
• Cluster 4: Connect A4 to ground
• Cluster 5: Connect A5 to ground

Integration with the Megajolt Lite Jr.

User outputs 1-4 + shift light output can be used to control the sequential shift light.

• Cluster 1: Connect A1 to MJLJ User Output 1
• Cluster 2: Connect A2 to MJLJ User Output 2
• Cluster 3: Connect A3 to MJLJ User Output 3
• Cluster 4: Connect A4 to MJLJ User Output 4
• Cluster 5: Connect A5 to MJLJ Shift Light Output

• For MJLJ wiring, see the Installation guide- [[1]] section.
• For software configuration, see the Operation Guide- User output configuration section.

Project Images

Shift light array assembled and illuminated